Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 158 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 158
4.
Example:
The following example sets the max-age MAXAGE ( 28 ) of bridge GROUP ( 1 ):
switch_a(config)#bridge 1 max-age 28
switch_a(config)#
Forward Delay (sec) (4..30):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the time (in seconds) after which (if this bridge is the root bridge) each port
changes states to learning and forwarding.
Use the no parameter with this command to restore the default value.
3.
Command Syntax:
bridge GROUP forward-time FORWARD_DELAY
no bridge GROUP forward-time
GROUP <1-1> The ID of the bridge group to which this delay time is assigned.
FORWARD_DELAY <4-30> the forwarding time delay in seconds.
4.
Example:
The following example sets the forward-time FORWARD_DELAY ( 30 ) of bridge GROUP ( 1 ):
switch_a(config)#bridge 1 forward-time 30
switch_a(config)#
RSTP PORT SETTING
Priority(Granularity 16):
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use this command to set the port priority for a bridge. The lower priority indicates a greater likelihood
of the bridge becoming root.
3. Command Syntax:
bridge GROUP priority PRIORITY
GROUP <1-1> the ID of the bridge group.
PRIORITY <0-240> The priority to be assigned to the group.
4. Example:
The following example sets the priority PRIORITY ( 100 ) of the interface fe1 (port 1) of bridge
GROUP ( 1 ):
switch_a(config)#interface fe1
switch_a(config-if)#bridge 1 priority 100
switch_a(config-if)#