Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 15 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 15
3.2.5
FITTING SFP CONNECTORS
Care should be taken when inserting/removing the SFP connectors from SFP ports as SFP modules are
Electrostatic (ES) sensitive and Electrostatic Discharge (ESD) precautions should be taken when
installing. Ensure that the SFP is fully engaged and latched into position.
Inserting SFP – Ensure that the SFP lever is in the locked position and insert into appropriate SFP
port. Gently push the SFP until it locks into place. Remove plastic/rubber dust cap and fit fiber cable or
RJ45 plug.
Removing SFP
– Remove fiber connector or RJ45 plug. Pull the SFP lever down to unlock SFP from
housing. Using the lever, gently pull the SFP out.
Fiber SFP
Copper SFP
Note: The 24 x 10/100BASE SFPs are mounted sideways. SFP handle/Latch must be inserted facing
left side as shown below.
FIGURE 8: FITTING/REMOVING SFP CONNECTORS
Inserting
SFP
Removing
SFP
1
2
Inserting
SFP
Removing
SFP
1
2