Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 148 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 148
2.
Usage:
Use poe enable command to enable this port to discover Powered Device (PD) connected to this port.
Use the no poe enable to disable this function.
3.
Command Syntax:
(no) poe enable
4.
Example:
The following example shows the use of poe enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe enable
switch_a(config-if)#
Power Limit by Classification:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use poe power-classification enable command to enable this port to provide power to PD according
to classification of maximum power range used by PD.
Use the
no poe power-classification enable to disable this function.
3.
Command Syntax:
(no) poe power-classification enable
4.
Example:
The following example shows the use of poe power-classification enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe power-classification enable
switch_a(config-if)#
Fixed Power Limit (W):
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use this command to specify the fixed power limit for this port to provide power to PD.
3.
Command Syntax:
poe fixed-power-limit LEVEL
LEVEL <1-15.4> specifies the fixed power limit (Watts) for this port to provide power to PD.