Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 160 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 160
Autoedge:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use spanning-tree autoedge command to assist in automatic identification of the edge port.
Use the
no spanning-tree autoedge
command to disable this feature.
3.
Command Syntax:
(no) spanning-tree autoedge
4.
Example:
The following example enables the spanning-tree autoedge of the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree autoedge
switch_a(config-if)#
Edgeport:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use spanning-tree edgeport command to set a port as an edge-port and to enable rapid transitions.
Use the
no spanning-tree edgeport
command to set a port to its default state (not an edge-port) and to
disable rapid transitions.
3.
Command Syntax:
(no) spanning-tree edgeport
4.
Example:
The following example enables the spanning-tree edgeport of the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree edgeport
switch_a(config-if)#
MSTP PROPERTIES
Region Name:
1.
Command Mode: MST Configuration mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to MST Configuration mode.
The
switch_a(config-mst)#
prompt will show on the screen.