Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 197 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 197
7.13 LLDP
LLDP General Settings, LLDP Ports Settings, LLDP Neighbors, LLDP Statistics
LLDP GENERAL SETTING
LLDP:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable Link Layer Discovery Protocol (LLDP) globally.
Use the no parameter with this command to disable Link Layer Discovery Protocol (LLDP) globally.
3.
Command Syntax:
(no) lldp enable
4.
Example:
The following example enables Link Layer Discovery Protocol (LLDP) globally:
switch_a(config)#lldp enable
switch_a(config)#
Holdtime Multiplier (2-10):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the Link Layer Discovery Protocol (LLDP) holdtime multiplier value. The
transmit interval is multiplied by the holdtime multiplier to give the Time To Live (TTL) that the
switch advertises to the neighbors.
3.
Command Syntax:
lldp holdtime multiplier <2-10>
<2-10> Holdtime multiplier 2-10, default is 4.
4.
Example:
The following example sets Link Layer Discovery Protocol (LLDP) holdtime multiplier to 5:
switch_a(config)#lldp holdtime multiplier 5
switch_a(config)#
Tx Interval (5-32768 seconds):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage: