Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 167 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 167
VLAN:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the Switch priority for running chain protocol. Switch with lower priority will
run as Master (forwarding) port. Use the no form of the command to restore default value (1).
3.
Command Syntax:
bridge <1-1> chain-vlan <1-4094>
no bridge <1-1> chain-vlan
<1-1> Bridge Group name for bridging.
<1-4094> The VID of the VLAN for chain on the bridge <1-4094>.
4.
Example:
The following example sets VLAN ID ( 1 ) for chain on bridge GROUP ( 1 ):
switch_a(config)#bridge 1 chain-vlan 1
switch_a(config)#
Chain Priority:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the Switch priority for running chain protocol. Switch with lower priority will
run as Master (forwarding) port. Use the no form of the command to restore default value (128).
3.
Command Syntax:
bridge GROUP chain-priority <0-255>
no bridge GROUP chain-priority
Group = <1-1> Bridge Group name for bridging.
<0-255> The Switch priority for running chain protocol.
4.
Example:
The following example sets the new Switch priority ( 10 ) to bridge GROUP ( 1 ):
switch_a(config)#bridge 1 chain-priority 10
switch_a(config)#
Chain Timeout:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#