Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 149 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 149
4.
Example:
The following example sets new fixed power limit 15 Watts to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe fixed-power-limit 15
switch_a(config-if)#
Power Priority:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use this command to specify the power priority to this port.
3.
Command Syntax:
poe power-priority PRIORITY
PRIORITY specifies high, medium, low power priority for this port.
4.
Example:
The following example sets high power priority to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe power-priority high
switch_a(config-if)#
Power Down Alarm:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use poe power-down-alarm enable command to enable power down alarm to this port.
Use the no poe power-classification enable to disable this function.
3.
Command Syntax:
(no) poe power-down-alarm enable
4.
Example:
The following example shows the use of poe power-down-alarm enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe power-down-alarm enable
switch_a(config-if)#