Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 134 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 134
Duplex:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use
duplex
command to specify the duplex mode to be used for each interface.
Use the no duplex to disable this function.
3.
Command Syntax:
(no) duplex MODE
MODE specifies the duplex mode: auto, full, half.
4.
Example:
The following example shows the use of duplex MODE ( full ) to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#duplex full
switch_a(config-if)#
Flow control:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use flowcontrol on command to enable flow control, and configure the flow control mode for the port.
Use the no flowcontrol to disable this function.
3.
Command Syntax:
flowcontrol on
no flowcontrol
4.
Example:
The following example shows the use of flowcontrol on to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#flowcontrol on
switch_a(config-if)#