Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 132 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 132
ALARM SETTING
Alarm-trigger if:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable or disable alarm trigger on interface.
3.
Command Syntax:
(no) alarm-trigger if INTERFACE
INTERFACE specifies the interface.
4.
Example:
The following example enables alarm trigger on interface “ fe1 ” to switch:
switch_a(config)#alarm-trigger if fe1
switch_a(config)#
Alarm-trigger power:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable or disable alarm trigger of power source.
3.
Command Syntax:
(no) alarm-trigger power POWER
POWER specifies the power source.
4.
Example:
The following example enables alarm trigger of power “ 1 ” to switch:
switch_a(config)#alarm-trigger power 1
switch_a(config)#