Optical Systems Design OSD2700SFP SERIES, Operator'S Manual

Page: 136 / 223

OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
OSD2700SFP OPERATOR MANUAL
PAGE 136
3. Command Syntax:
sfp set-temp IFNAME high-alarm
｜
high-warning
｜
low alarm
｜
low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration information is desired.
LEVEL Threshold value -128 ~ 12
8℃
.
4.
Example:
The following example sets high temperature alarm threshold 100
℃
for SFP transceiver of interface
ge1 (port G1):
switch_a(config)#sfp set-temp ge1 high-alarm 100
switch_a(config)#
Voltage Alarm (Warning) Threshold:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set voltage alarm (warning) threshold for SFP transceiver.
3.
Command Syntax:
sfp set-vcc IFNAME high-alarm
｜
high-warning
｜
low alarm
｜
low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration information is desired.
LEVEL Threshold value 0 ~ 6.55 volts.
4.
Example:
The following example sets high voltage alarm threshold 6 volts for SFP transceiver of interface ge1
(port G1):
switch_a(config)#sfp set-vcc ge1 high-alarm 6
switch_a(config)#
Tx-bias Alarm (Warning) Threshold:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set transmitter laser bias alarm (warning) threshold for SFP transceiver.
3.
Command Syntax:
sfp set-tx-bias IFNAME high-alarm
｜
high-warning
｜
low alarm
｜
low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration information is desired.
LEVEL Threshold value 0 ~ 131 mA.
4.
Example:
The following example sets high transmitter laser bias alarm threshold 131 mA for SFP transceiver of
interface ge1 (port G1):
switch_a(config)#sfp set-tx-bias ge1 high-alarm 131
switch_a(config)#