Omron NS10-TV Series, Programming Manual

Page: 72 / 682

Section 2 NS Series Functions 2-4 System Memory
2-23
NS Series Programming Manual
Data Input Detector ($SB5)
$SB5 detects numeral and character input. $SB5 turns ON when numeral and character (virtual key-
board) input dialog boxes are opened and turns OFF when these dialog boxes are closed.
If Input from Pop-up Screen is specified as the input method in the input functional object for numeral
or character string display and input, $SB5 will turn ON when the pop-up screen is opened and will
turn OFF when the focus is moved to another object. If
Other Input Method (command button, etc.) is
specified, $SB5 will turn ON when the focus is on the object and will turn OFF when the focus leaves
the object.
Brightness Adjust ($SB6, $SB7, and $SB8)
$SB6 to $SB8 are used to adjust backlight brightness.
$SB6 is used to adjust the backlight brightness to high. The brightness can be adjusted to high by
turning ON $SB6.
$SB7 is used to adjust the backlight brightness to middle. The brightness can be adjusted to middle by
turning ON $SB7.
$SB8 is used to adjust the backlight brightness to low. The brightness can be adjusted to low by turn-
ing ON $SB8.
If the screen saver has started, the screen saver will remain even if $SB6, $SB7, or $SB8 is turned
ON.
N
N
N
o
o
o
t
t
t
e
e
e
♦
If more than one of these bits turns ON at the same time, the priority order of brightness is high,
middle, and then low.
♦
If bits $SB6 to $SB8 are all turned OFF, the background brightness will be high.
♦
If external adjustment of the brightness is specified for the NS15 backlight from the System Menu,
&SB6 to &SB8 cannot be used to adjust the brightness of the backlight. Refer to the NS-series PT
Setup Manual for information on the System Menu settings for the backlight brightness.
Backlight Control (Screen Saver Start/Cancel, $SB9)
When $SB9 turns ON, the backlight will go out 3 seconds later and the screen saver will start. When
$SB9 turns OFF, the screen saver is canceled and the backlight turns ON. Even if the screen saver is
set to OFF on the PT Tab Page of the System Settings, the screen saver will start when this bit turns
ON. The screen saver will also be canceled if the screen is touched while the screen saver is being
displayed. If $SB9 is turned ON while the Control Backlight Flashing bit ($SB10) is ON, the backlight
will flash. $SB9 will turn OFF.
Control Backlight Flashing ($SB10)
$SB10 controls backlight flashing. When $SB10 turns OFF, the backlight is lit and when $SB10 turns
ON, the backlight flashes.
If the screen saver has started, the screen saver will remain and the screen will not flash even if $SB10
is turned ON. If $SB10 is ON when the screen saver is closed, the screen will start flashing after the
screen saver has closed.
If the screen is switched to System Menu while the backlight is flashing (i.e., $SB10 is turned ON), the
flashing will stop. The flashing will start again when the screen is changed back from System Menu.
If an error dialog box is displayed while the backlight is flashing (i.e., $SB10 is turned ON), the flashing
will stop. The flashing will start again when the error dialog box is closed.
Backlight Status ($SB11)
$SB11 indicates the status of the backlight. $SB11 turns ON while the backlight is not lit.