Omron K3NP, Operation Manual

Page: 33 / 121

24
Performance Characteristics
Accuracy of measurement ±
0.08% rdg
±
1 digit (ambient temperature: 23 ° C
±
5 ° C)
Measurement range 20 ms to 3200 s
Response time of HOLD input 20 ms max.
Recovery time (T
R
) 20 ms min.
ON/OFF pulse width
Sensor with transistor output: 9
m
s min.
Sensor with relay output: 15 ms min.
Response time Output configuration
Relay output Transistor
output
BCD and
transistor output
Linear and
transistor output
Communication
and transistor
output
Comparative output 25 ms max. 20 ms max. 35 ms max. 35 ms max. 20 ms max.
BCD output --- --- Refer to page 93. --- ---
Linear output --- --- --- 40 ms max. ---
The response time of the HOLD input is the time required for the K3NP to
accept HOLD input after the HOLD input turns ON. This is illustrated in the
following diagram.
Available functions in this mode are indicated as “Yes” in the following table.
Menu Function Displayed
Character
Availability Reference
page
--- Max./Min. value display and reset --- Yes 82
sUset
(note 1) Set value bank no. of set values
s.bank
Yes 42 ( )
HH set value
sU
*
.hh
H set value
sU
*
. h
L set value
sU
*
. l
LL set value
sU
*
.ll
pscl
Set value bank no. of prescale values
p.bank
Yes 46
Prescaling value of input A
X (mantissa)
Y (exponent)
ps
*
.ax
ps
*
.ay
Yes
Decimal point position
decp.
*
Yes
setup
Operating mode
func
Yes 50
Input A sensor type
ina
Yes
52
Input B sensor type
inb
No
Time unit
time
Yes 54
Communications unit no. (note 1)
u-no
Yes 56
Baud rate (note 1)
bps
Yes
Word length (note 1)
len
Yes
58
Stop bits (note 1)
sbit
Yes
Parity bits (note 1)
prty
Yes
opt
Output pattern (note 1)
c-out
Yes 61
H linear output range (note 1)
lset.h
Yes 64
L Linear output range (note 1)
lset.l
Yes
Remote/Local programming (note 1)
r-l
Yes 67
Note 1. The availability of the parameters depends on the type of selected Output
Board.
2. The selected bank number will be displayed where the asterisk (
*
) appears.
Response Time of HOLD
Input
Cycle:
f2
Section 3-2