Omron F39-MC11, Instruction Manual

Page: 29 / 35

- 49 -
①
②－１ ②－２ ②－３
Setting limitation
No.of fixed zones No.of fixed beams No.of floating beams
No.of fixed zones No.of fixed beams
No.of floating beams
2: 2 zones
3: 3 zones
1: 1 zone
0: 0 zone (disabled) 1: 1 beam
2: 2 beams
9: 9 beams
0: 0 beam (disabled)
Setting completed
Setting completed Setting completed
③－１ ③－２ ③－３
Go to ②－１
after 1 sec
・
・
・
3.LMT
1.X.FD 2.X.NO. 3.L.NO.
④－１ ④－２ ④－３
RST: Reset limitation
1: 1 beam
2: 2 beams
3: 3 beams
GOOD GOOD GOOD
Go to ②－２
after 1 sec
Go to ②－３
after 1 sec
RST: Reset limitation RST: Reset limitation
Blinking
[Cancel] Key
[Enter] Key
[Up][Down] Key
- 50 -
11 DISCONNECT F39-MC
After the setting has completed, be sure to disconnect cable and
F39-MC before normal use.
Operation procedure;
1. Disconnect F39-MC and cable from branching connector.
2. Attach connector cap to branching connector.
(Without the connector cap, water resistance cannot be maintained.)
CAUTION
Be sure that the machine power is OFF when disconnecting.
Disconnecting with the power ON may cause the F39-MC to
malfunction.
Connector Cap
Please set this to branching
connector when F39-MC is
not in use.
①
②