Omron F39-MC11, Instruction Manual

Page: 16 / 35

- 23 -
①
②－１ ②－２ ②－３ ②－４ ②－５
Go to ②－３
Go to
②－４ Go to ②－５
Floating blanking
Sequential mode Function Valid Floating beam no. Outermost beam invalid
Function valid Floating beam no. Sequential mode
Outermost beam invalid
Send to sensor
Setting completed
Error
Blinking
[Cancel] Key
[Enter] Key
[Up][Down] Key
1:1 floating beam
Go to ①
after 1 sec.
2:2 floating beams
3:3 floating beams
CLR: floating beams
clear
2.FLO
1.FUN
②－１－１
2. NO. 3.SEQ 4.O.B.I. SEND
②－２－１ ②－３－１ ②－４－１ ②－５－１
Go to ②－２
ON:Valid
OFF:Invalid
ON:Valid
OFF:Invalid
ON:Valid
OFF:Invalid
GOOD
ERR
- 24 -
8.3 Auxiliary output
<F3SN, F3SH>
This is a non-safety related output used to display a status.
This output cannot be used for the purpose of safety.
This can be selected to the following output;
1. Dark ON
2. Light ON
3. Light diagnosis
4. Lockout
5. Outermost beam monitoring
6. Blanking monitoring
7. Specified beam
For detail of each output, please refer to ANNEX1 INDEX.
<Note>
Because F3SH does not have fixed blanking function, “6. Blanking
monitoring” is not selectable.
8.4 Output2
<F3ZN>
This is a output of F3ZN used to display a status.
Available signals are the same as 8.3 Auxiliary output.