- 41 -
9 COPY
This function allows you to copy settings of one sensor and transfer
them to another sensor. The settings which can be changed in
Monitor/Set mode, will be copied. (Including ID)
Inside the F39-MC are banks of the memory to store the date of sensor.
The data will not be deleted in case of power OFF since the data in the
bank is stored in EEPROM.
Bank lock setting protects data from being deleted by mistake.
The numbers of banks are listed below. Each bank can store setting
data of one sensor.
F3SN : 1
F3SH : 1
F3ZN : 9
<Note>
1. Banks will be allocated independently to sensor models (F3SN/F3SH
/F3ZN). Copying to a sensor with different model is not possible. For
example, copying from F3SN to F3ZN is not possible.
2. Copying to sensor with different detection capability (or beam gap) is
not possible.
Switch modes are illustrated below;
Section9.1(42page) Section9.2(43page) Section9.3(44page)
1.Upload
2.Download
3.Bank Lock
1.U.LD
2.D.LD
3.B.LC
[UP][DOWN]Key
Blinking
- 42 -
9.1
Upload (Copy Sensor data to F39-MC)
Copy the setting data of one sensor to the bank of F39-MC.
Select <1.U.Ld> and press [ENTER] key. Bank from 1 to 9 can be
changed with using [UP][DOWN] keys (F3ZN only).
The illustration below shows that setting data from the sensor is stored
into bank 1 of F39-MC.
Select bank number using
[UP][DOWN]
keys.
Note: F3SN/F3SH has only
Bank1
Upload
Upload
Setting completed
Error
Blinking
[Cancel] Key
[Enter] Key
1.U.LD
①
②
BK 1:Bank #1
GOOD
ERR
Go to
①
after 1 sec.
③
<Note>
Bank 1 for F3SN, F3SH and F3ZN are stored in different memories.
