Omron E5ZN-DRT, Operation Manual

Page: 96 / 162

81
Operations from the Edit Device Parameters Window Section 5-2
Setting Method
1,2,3... 1. Open the Edit Device Parameters Window for the DeviceNet Communica-
tions Unit, select the General Tab Page, and click the Set Button.
The Edit Unit Parameters Window will be displayed.
2. Enter the name or other comment in the Comment field.
3. Click the OK Button to return to the Edit Device Parameters Window.
Note If the window is exited by clicking the Cancel Button or Button,
all the new settings will be canceled. Always click the OK Button to
exit the window.
4. To continue setting comments for other Temperature Controllers, repeat
the procedure from step 1.
5. After entering comments for each Temperature Controller, return to the
General Tab Page and click the Download Button to write the comments
to the DeviceNet Communications Unit in a batch.
5-2-11 Setting Temperature Controller Monitor Mode and Monitor Values
A conduction time monitor and total RUN time monitor can be used to calcu-
late the conduction time or RUN (control) time of connected Temperature
Controllers and record the time in the DeviceNet Communications Unit. When
the total time exceeds the set monitor value, the Temperature Controller Main-
tenance Bit in the Unit Status Area will be turned ON.
These monitors provide a guideline for when to replace the Temperature Con-
trollers.
Set whether to total the Unit conduction time or RUN time using the MONI-
TOR mode.
Measuring unit: 0.1 h (The Configurator display is in 1-h units.)
Measured time: 0 to 429496729 h
(stored data: 00000000 to FFFFFFFF hex)
Monitor value setting range: 0 to 429496729 hours
The present values for the conduction time or RUN time, and the Unit status
can be checked from the Maintenance Mode Window.
Note 1. The present values and monitor values for conduction time or RUN time
are stored even when the power is turned OFF.