![background image](http://html1.mh-extra.com/html/omron/e5zn-drt/e5zn-drt_operation-manual_742104142.webp)
127
Maintenance
Section 8-2
Write Setting Parameters
(Download)
Use this function to download the setting parameters from the DeviceNet
Communications Unit to the Temperature Controllers.
Note
1.
While downloading, refresh processing of I/O data will stop, and the data
immediately before being copied will be held in the IN Area of the De-
viceNet Communications Unit. Explicit message communications will stop,
so a timeout error may occur.
2.
After downloading has been completed, a software reset will be imple-
mented for the Temperature Controller. Even if the Temperature Controller
is in RUN mode, the Controller will stop after downloading when the follow-
ing conditions are met.
• The RUN/STOP Bit in the OUT Area for the channel is ON.
• The Output Enable Bit in the OUT Area for the channel is OFF.
■
Execution Condition
• Data for the same connection configuration (model, unit number) has
been uploaded to the DeviceNet Communications Unit.
• There can be no communications error (TS indicator is not flashing red).
■
Procedure
1,2,3...
1.
Turn ON pin 2 (download) of the DIP switch on the front of the DeviceNet
Communications Unit.
2.
Toggle pin 1 of the of the DIP switch on the front of the DeviceNet Commu-
nications Unit from OFF to ON (leave ON for 1 to 5 seconds) and then turn
OFF again (while pin 1 is ON, the TS indicator will be flashing green). The
data will start downloading and the TS indicator will flash green.
■
Execution Results
• When the download completes normally, the TS indicator status returns to
be lit green.
• When the download operation ends abnormally, after error completion,
the TS indicator will flash red for 10 s.
Note
1.
For the download operation, when pin 1 (copy) is turned ON, the TS indi-
cator will flash green (indicating download standby). Check that the TS in-
dicator is flashing green before turning OFF pin 1 (copy) again.
E5ZN
UNIT
BPS
POWER
ERROR
SD/RD
OUT1
OUT2
SUB1
SUB2
E5ZN
UNIT
BPS
POWER
ERROR
SD/RD
OUT1
OUT2
SUB1
SUB2
E5ZN
UNIT
BPS
POWER
ERROR
SD/RD
OUT1
OUT2
SUB1
SUB2
E5ZN
UNIT
BPS
POWER
ERROR
SD/RD
OUT1
OUT2
SUB1
SUB2
E5ZN
Downloading
DeviceNet
Communications
Unit
Temperature Controllers
ON
UP/DN
COPY
12
12
12
TS
TS
Copy operation mode setting
Start copying
Turn ON
pin 2
Leave pin 1 ON
for 1 to 5 s
Indicators
Lit green
Flashing green
Flashing green
TS
Summary of Contents for E5ZN-DRT
