Omron CVM1-CLK21, Operation Manual

Page: 55 / 309

39
Installation Section 3-2
Dimensions (Unit: mm)
3-2 Installation
The Controller Link Unit is mounted onto a CPU Backplane or Expansion CPU
Backplane for use. For detailed information on into a PC installation proce-
dures, refer to the PC Installation Guide.
Note 1. Always turn off power to the PC before mounting the Controller Link Unit
into the Backplane or connecting the Bus Connection Unit.
2. Be sure that all screws on the Backplane, the Bus Connection Unit, the ter-
minal block, and cables are tightened firmly. If screws work loose, a mal-
function may occur as a result of vibration.
3. A label has been placed over the upper surface of the Controller Link Unit
to prevent scraps of wire from entering the Unit. Conduct wiring and instal-
lation with this label in place. If wire scraps get into the Unit, it will malfunc-
tion.
4. Remove the label after wiring and installing the Controller Link Unit to pre-
vent overheating. Overheating will cause the Unit to malfunction.
32
110
122.8
15.8
k
bit/s