Omron CVM1-CLK21, Operation Manual

Page: 202 / 309

186
Setting Routing Tables Section 7-4
7-4-3 Editing Relay Network Tables
Use the routing table editing function on the Programming Device to edit the
local network table as shown on the screen given below.
End network:
Network address of the end network (1 through 127)
Relay network:
Network address of the first relay point on the way to the end network (1
through 127)
Relay node:
Node address of the first relay point on the way to the end network
(SYSMAC NET: 1 through 126, SYSMAC LINK: 1 through 62, and Controller
Link: 1 through 32, Ethernet: 1 through 127)
Set all networks not directly connected to the PC.
Be sure to set the same address for each network when setting routing tables
(local and relay network tables) in multiple PCs.
Note 1. Do not set the same end network more than once with the C200HX/HG/
HE or CQM1H-series PCs. Routing may fail.
2. The PC ID is any unique name given to a specific node.
When setting the PC ID, simply input the ID. Network and node addresses
will be input for you automatically. See the operation manual for SYSMAC,
CV, or Controller Link Support Software for further details.
7-4-4 Saving Routing Tables
After editing local and relay network tables on the Programming Device, save
the tables.
Note When setting routing tables in multiple PCs, edit and save all routing tables
and then transfer them together to work more efficiently.
7-4-5 Connecting to the PC
Connect the Programming Device to a PC in the network to transfer the rout-
ing tables. All PCs receiving the routing table settings must have power turned
ON for the transfer.
Note The Programming Device must be disconnected and then reconnected to a
PC on each network.
7-4-6 Routing Table Enable Bit (C200HX/HG/HE and CQM1H-series
Only)
Routing tables are written to DM 6450 through DM 6499 with C200HX/HG/HE
and CQM1H-series PCs. Do not write any other data in these words when
using routing tables.