Omron CVM1-CLK21, Operation Manual

Page: 240 / 309

224
Troubleshooting Using Indicators Section 9-1
Troubleshooting with LNK and M/A Indicators
Data Link Cannot be
Started The following table describes the LNK and M/A indicators at the startup node
and their use in troubleshooting when a data link cannot be started.
Starting a data link depends on the Controller Link Unit operating normally
and participating in the Network. Refer to Troubleshooting with RUN, ERC,
ERH and INS Indicators earlier in this section and check Unit operation before
using the following table.
Indicators Probable cause Probable remedy
LNK M/A
Lit --- Data link operating normally. ---
Flashing --- There is an error in the data
link tables. If the ERH indicator is lit, reset
the data link tables.
When manual setting is used,
either data link tables have not
been created for the startup
node or there is an error in the
data link tables. Refer to 5-2-2 Manual Setting
and set data link tables for the
startup node.
When automatic setting is
used, either the data link
parameters for the startup
node have not been set or
there is an error in the data link
tables. Refer to 5-2-4 Automatic Set-
ting: “Select All” and set the
automatic parameters for start-
ing the data links.
Not lit Lit Manually set data links are
already operating on the same
Network. Stop the manually set data
links that are operating and
restart the data links.
Not lit Not lit Automatically set data links
are already operating on the
same Network. Stop the automatically set data
links that are operating and
restart the data links.
There is an error in the startup
node PC. Refer to the PC’s operation
manual and correct the error. If
the error reoccurs, replace the
PC.