134
Using General-purpose Tools to Set Devices
Section 6-4
• Service code
•
Class (object class), instance (class instance) and attribute (instance
attribute)
Before setting the device parameters, it is also necessary to obtain the data
setting information on attributes other than the above from the manufacturer
of the device.
Unless all the information is known, the device parameters cannot be set.
Use the following procedure to set the device parameters.
1, 2, 3...
1.
Place the Configurator online.
2.
Select
Tools
and
Setup Parameters
.
The following window will be displayed.
3.
Set the
Target Node Address
to the node address of the device.
4.
Designate the service.
There are two ways to designate the service code, using the generic ser-
vice code defined by DeviceNet or designating it directly. To use the gener-
ic service code defined by DeviceNet, check the
Generic
option, then
select the desired service from the drop-down list. To designate the service
code directly, check the
Custom
option, then input the service code in a
HEX format string.
Summary of Contents for 3G8E2-DRM21-EV1
