23
ISA Board Installation
Section 2-2
Note The setup for the ISA Board or PCMCIA Card can be performed later
by clicking the
Start
Button, then selecting
Program
,
DeviceNet
Tools
,
3G8F5/3G8E2-DRM21 Setup
,
3G8F5/3G8E2-DRM21-Set-
up
.
10. The setup program for the device driver will start. There is already a card
driver registered, so click the
Edit
Button. The New selection is used to add
a driver for the ISA Board or PCMCIA Card.
The
Remove
selection is used to delete the selected driver.
Note a) The card name that is displayed first depends on the operating en-
vironment.
b) The card name registered here will be used on the Configurator to
access the ISA Board or PCMCIA Card.
c) Register a name for each ISA Board and PCMCIA Card.
11. Set the I/O port address, memory address, and interrupt (IRQ) for the ISA
Board or PCMCIA Card being used with the Configurator. (Refer to the
screen in step 12. )
12. Input the I/O port address set on the board’s DIP switch and input a mem-
ory address that is available in the computer. Set the interrupt to None.
The Card Name and Driver Name can be changed if necessary.
Make sure that all of the settings are correct and click the
OK
Button. The
Configuration Window shown in step 10 will be displayed.
Note a) The Configurator does not use interrupts. Set the interrupt level to
None
.
b) Do not select
-V1 Type
in the above Card Setup Dialog Box when
using an ISA Board.
Summary of Contents for 3G8E2-DRM21-EV1
