136
Using General-purpose Tools to Set Devices
Section 6-4
c)
Input
Data Area
for the
Attribute
of the parameter to be read.
d) Click the
Send
Button. The value that was read will be displayed in the
Result
area.
2.
Parameter setting example
a) Check the
Generic
option in
Service
, then select
Set Attribute Single
from the drop-down list.
b) Designate the class and instance of the parameter to be set.
c)
Input
Data Area
for the
Attribute
of the parameter to be set.
d) Input the attribute followed by the value to be set for the parameter in
the Data area.
e) Click the
Send
Button.
6-4-2
Setting Node Addresses and Baud Rates through the Network
Tools - Setup Node Address/Baud Rate
To set the node address and baud rate for the device through the network,
use the following procedure.
1, 2, 3...
1.
Set the DeviceNet network so that only the objective device and the Con-
figurator are in operation on the network. Refer to the operation manual of
the device for the factory-set node address and baud rate of the device.
Connect the Configurator to the network at the same baud date.
2.
Place the Configurator online.
3.
Select
Tools
and
Setup Node Address/Baud Rate
.
The following window will be displayed.
4.
Set the
Target Node Address
to the present node address of the objective
device.
5.
To change the node address, set the
New Node Address
to the new node
address and click the
Change
Button.
The node address will be changed.
Summary of Contents for 3G8E2-DRM21-EV1
