92
Advanced Settings (Connection, Communication Cycle Time, Slave Function Settings, Etc.)
Section 4-9
Connections
Connection
Tab
When the user specifies the connections for remote I/O communications, up
to two connections can be set for each slave.
Use the following procedure.
1,2,3...
1.
Select the slave in the Registered Device List.
2.
Click the
Advanced Setup
Button.
3.
The following window will be displayed.
Click the
Connection
Tab.
Automatic connections are set by default.
To specify the connections, use the following procedures.
1,2,3...
1.
Select
User Setup
.
Possible connections are ready for selection.
2.
Select the connections.
Up to two connections can be selected.
Note Both
COS
and
Cyclic
cannot be specified at the same time.
3.
Set the connection path as needed.
4.
Set the COS/Cyclic heard beat timer.
5.
Click the
OK
Button.
An asterisk (*) will be displayed in the C column at the right edge of the
Registered Device List. If the connections of a device already allocated
with I/O are changed, the previous I/O allocations will be canceled. Make
the I/O allocations again.
Note
1.
Both COS and Cyclic settings cannot be made at the same time.
2.
If
Poll
and
COS
settings or
Poll
and
Cyclic
settings are used in combina-
tion, check that the output settings of the both connections are the same.
3.
The automatic allocation function is not possible for devices if the user al-
ready made connections settings for the devices with the advanced setup.
Summary of Contents for 3G8E2-DRM21-EV1
