2-9
2.5 Labels And Serial Number Info
The UWBT transmitter handle comes with 2 labels affixed to the enclosure.
The front label gives you the basic information for operation, and the rear label
provides information specific to your model and part.
Figure 2-13. UWBT Front Label
The rear label is marked with international safety and hazard symbols in
accordance with IEC standards (see section 9). It is important to read and
follow all precautions and instructions in this manual before operating or
commissioning this device as it contains important information relating to safety
and EMC. Failure to follow all safety precautions may result in injury and or
damage to your device. Use of this device in a manner not specified will void
your warranty.
Figure 2-14. UWBT Rear Label
Transmitter Instructions (Hardware)
2
2-9
UWBT SERIES
WIRELESS TRANSMITTER
PWR/
ALARM
TX/
LOG
POWER
USB
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: 1. This device may not cause harmful interference; 2. This device must accept any interference received,
including interference that may cause undesired operation.
The LED on the left provides indications
related to Power and Alarm Status.
The LED on the right provides
indications related to Data Transmission
and Logging.
The Bluetooth® word mark and logos
are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such
marks by Omega Engineering is under
license. Other trademarks and trade
names are those of their respective
owners.
The PAIR key is used to put the
transmitter into discovery mode.
This label includes the following
FCC Notice:This device complies with
Part 15 of the FCC rules.
Operation is subject to the following
conditions:
1. This device may not cause harmful
interference;
2. This device must accept any
interference received, including
interference that may cause
undesired operation
PAIR
IEC Symbol:
EU’s Waste Electrical and Electronic
Equipment Compliance
IEC Symbol:
Caution, refer to accompanying
documentation
