![background image](http://html1.mh-extra.com/html/omega/uwbt-series/uwbt-series_user-manual_4162735018.webp)
2.3.4 M12 Connection (for RH Model)
The UWBT-RH model is supplied with its mating M12 RH sensor probe. See
below for instructions on connecting the probe:
Figure 2-10. M12 Connection For RH Model
2.3.5 BNC & Terminal Block Connection (for pH Model)
The UWBT-pH model has connection for both a BNC connector (for a
pH electrode) and a 2-wire RTD terminal block (for solution temperature
compensation).
See below for instructions on connecting the pH and RTD sensors.
Figure 2-11. BNC And Terminal Block Connection For pH Model
Transmitter Instructions (Hardware)
2
2-6
ROTATE THIS NUT
MAKE SURE NOT TO ROTATE
BY GRIPPING THE
STAINLESS STEEL TUBE. THIS
WILL EXPOSE THE SENSOR
1. Pull the probe into the UWBT
Handle, matching up the pins.
2. Rotate the probe's silver nut while
holding the handle steady, rotate until
there is a tight fit.
MAKE SURE TO ROTATE THE PLUG
UNTIL THE ROUND TAB GOES INTO
PLACE.
pH ELECTRODE