10-004209-01EN [Q7750159], Rev. 2, May 2018
Chapter 6
204
Figure 6
‑
1 Joystick off center screen
Ensure the handheld controller’s joysticks are free of interference, and then reset the
system power to enable joystick control. If no interference of the joystick is present,
the joystick calibration may need to be performed (see “Joystick Calibration Screen”
on page 89)
6.1.2
Checking Network
Figure 6
‑
2 The Checking Network message
During start-up, the system initializes the communications to all the devices on the
network (see “System Start-Up” on page 57 for start-up instructions). If the network
communication fails for any reason, the “Checking Network” message will appear
and remain on screen (see Figure 6-2 on page 204).
The following are some likely causes of this failure:
Checking
network
failure
message
Summary of Contents for SteerROVER
