10-004209-01EN [Q7750159], Rev. 2, May 2018
System Components
171
4.10 Probe Holder Rack
This section provides information on probe holder rack components and how to set
up and use them.
Although the images in the instructions in “Probe Holder Rack—Flat or
Circumferential” on page 171 contain images of a probe holder rack with straight,
nonpivoting frame bars, the same principles apply to the pivoting probe holder rack.
4.10.1
Probe Holder Rack—Flat or Circumferential
The probe holder rack adds weld scanning capability to the SteerROVER motorized
scanner (see Figure 4-108 on page 172). This frame uses four (4) vertical probe holders.
Additional frame components allow up to six probes to be used.
NOTE
Summary of Contents for SteerROVER
