10-004209-01EN [Q7750159], Rev. 2, May 2018
Chapter 3
90
Figure 3
‑
39 Joystick error
This calibration may also be used when a joystick function does not appear to be
properly centered.
Current readings of the joysticks are displayed in the
Joystick Calibration
screen (see
Figure 3-40 on page 91). When the numbers are not near zero, press the
Calibrate
button to recalibrate to 0. The new calibration is stored when the
Exit
button is
pressed.
It may be necessary to validate that the calibration is centered by testing each joystick
in both directions. If one direction results in a greater offset from zero, it may be
necessary to position the joystick in the middle of the difference, and then press
Calibrate
. For example, if pressing the joystick in one direction and releasing it gives a
value of 10, yet doing the same in the other direction gives a value of
−
50, move the
joystick until the value reaches
−
20 and then press
Calibrate
.
Summary of Contents for SteerROVER
