10-004209-01EN [Q7750159], Rev. 2, May 2018
System Components
179
4.10.2.2
Pivoting Probe Holder Rack Setup—Longitudinal
FALLING OBJECT HAZARD. When scanning in the longitudinal direction with the
pivoting probe holder rack, operation must be limited to driving in the longitudinal
direction only. Only very slight corrective steering is permitted. Excessive steering
may cause the SteerROVER to fall and SEVERE INJURY or DEATH could result.
To set up the pivoting probe holder rack for longitudinal scanning
1.
Loosen the pivot wing knobs at the center of the rack system (see Figure 4-116 on
page 180).
The swivel mount must be in a horizontal position during longitudinal scanning (see
“Swivel Mount” on page 95).
WARNING
NOTE
Summary of Contents for SteerROVER
