10-004209-01EN [Q7750159], Rev. 2, May 2018
Preparation for Use
37
Figure 1
‑
7 Reversing the shackle orientation for low
‑
profile scanning
1.4
Preparation of Inspection Surface
FALLING OBJECT HAZARD. The inspection surface must adhere to the conditions
outlined in “Intended Use” on page 23 and “Unintended Use” on page 24 of this
manual.
To prepare the inspection surface
1.
Remove build-up of scale, and other debris (ex.: dirt, ice) from the surface on
which the SteerROVER is to drive.
Excessive build-up will cause the wheels to lose magnetic attraction, which may
lead to wheel slippage or scanner detachment.
2.
Ensure that no obstructions (other than standard butt welds) or voids are in the
drive path.
WARNING
Summary of Contents for SteerROVER
