10-004209-01EN [Q7750159], Rev. 2, May 2018
System Components
185
4.
Loosen the pivot wing knob and align the frame bar parallel with the scan surface
(see Figure 4-122 on page 185).
Figure 4
‑
122 Align frame bar with flange scan surface
4.10.2.5
Laser Guide Pivot Mount
A mounting point for the laser guide is included with SteerROVER weld packages
(see “Battery-Powered Laser Guide (Optional)” on page 186). To install the pivot
mount, see these following instructions.
To install the laser guide pivot mount
1.
Remove the dovetail bar pivot (1) from one of the sets of probe holder racks (see
Figure 4-123 on page 186). The choice of which dovetail bar pivot to remove is at
your discretion.
2.
Attach the laser guide pivot mount (2) to the frame bar (see Figure 4-123 on
page 186), tighten the dovetail knobs and the dovetail screws. Ensure a flush
alignment of the pivot mount and the frame bar to achieve proper centering of the
laser guide pivot mount.
Summary of Contents for SteerROVER
