Chapter 1 Using the Operator Panel
1-30
You can set the number of copies to be printed of each page
for the current interface. The number of copies can be set be-
tween 1 and 999. The number of copies can be set whenever
the message display indicates
Ready
.
Press the
MENU
key.
Press the or key repeatedly until
Page Set >
appears.
Press the key.
Press the or key repeatedly until
>Copies
ap-
pears.
Press the
ENTER
key. A blinking cursor (
_
) ap-
pears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking. It can
be set between 1 and 999. You can use the and
keys to move the cursor right and left.
When the desired size is displayed, press the
ENTER
key.
Press the
MENU
key. The message display returns to
Ready
.
You can print with the reduced size. This menu is used to set
the source paper size and the paper size to use after reduc-
tion.
• Printed results when making reductions differ from equivalent
size printing. Sometimes the line width of characters may not
be consistent or lines may appear in figures or image patterns.
Also, thin lines may not be reproduced on the reduced print.
• In the reduction mode, printed barcodes may not be read.
Bring up the
Zoom
menu. The following display will appear.
Source size indicator
...
This is the paper size before reduc-
tion.
This must be the same as the paper size set for print data
from the computer.
Target size indicator
...
This is the paper size after reduction.
This must be the same as the paper size set for the paper cas-
sette.
Setting Number of Copies
Page Set >
>Copies
001
>Copies
001
1
2
3
4
5
6
7
8
Selecting Reduced Print
NOTE
>Zoom
[CS]
→
[CS]
Target size indicator
Source size indicator
