Oce Arizona 500, User Manual

Page: 15 / 156

Product Description
7/26/04 1-3
printer can be run with media routed to the EMTU or to the conventional internal roller.
The EMTU contains a holder for the conventional roller when it is not in use (see Figure
1-1).
Figure 1-1 Media Take-up Roller Holder
Firmware changes that accommodate the Print & Go feature present a few operational
changes, including:
• Whenever the ADVANCE MEDIA button is used to reposition the media, no
adjustment of the position occurs at the beginning of the next print. The effect
of the button is the same as if the user pressed the CANCEL button to
terminate the ADVANCE MEDIA function.
• Océ strongly recommends that only a small amount of media be rewound
using the ADVANCE MEDIA button because the exposed media may not
track smoothly back through the printer.
• When in Print & Go mode, the operator can ignore the take-up roll diameter
question because that diameter is not used.
• The MEDIA USED value (feet/meters) is not displayed on the control panel.
• Every print must pass through a dry cycle to prevent wet ink from offsetting
onto the lower black roller. (When a print enters the drying: cycle, a print
cannot be cancelled. If another print was in the queue prior to the print being
cancelled, the operator is given the option to continue drying or to cancel the
print.)
The media loading procedure for Print & Go mode is documented in “Print & Go Media
Installation” on page 3-15.