Oce Arizona 500, User Manual

Page: 78 / 156

Océ | Control Panel
4-24
Media Type: Other
Selecting Other enables additional menus for manual media setup. When changing values,
holding the +/- buttons continuously increments or decrements the value repeatedly.
Follow the steps below for this media type option:
1. Navigate to:
MEDIA MENU
Other
2. Press the ACCEPT button. You then see:
MEDIA MENU
thickness: (2.00 - 30.00) mil
The range for thickness values is 2.00-30.00 mils. The media thickness is typically
on the media container label, if any. The media thickness changes by .05 mils.
Use the +/- buttons to increment or decrement the thickness setting.
3. Press ACCEPT. You then see:
MEDIA MENU
takeup core OD: (3.10" - 4.00")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
4. Press ACCEPT. You then see:
MEDIA MENU
supply core OD: (3.10" - 4.00")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
5. Press ACCEPT. You then see:
MEDIA MENU
4-pass servo target temperature: 150F
The temperature increments or decrements by 1 degree. The maximum
temperature setting is 155
º
F. Use the +/- buttons to change the temperature
setting.
6. Press ACCEPT. You then see:
MEDIA MENU
8-pass servo target temperature: 135F