Oce Arizona 500, User Manual

Page: 50 / 156

Océ | Media System
3-24
This feature enables the adjustment of media stepping to compensate for variation
in media lots and environmental factors. The plus direction lengthens each media
step. The minus direction shortens each media step.
For additional information, see “Firmware 2.2 Notes” on page C-12.
24. Press ACCEPT. You then see:
Sizing media
please wait
The printer sizes the media. If an error occurs, check the alignments along the
media path from the supply to the take-up core.
If no error occurs, you then see:
MEDIA MENU
media delivery mode: roll to roll or Print & Go
Use the +/- buttons to select Print & Go.
25. Press ACCEPT. You then see:
Stabilizing media
please wait
When stabilizing is complete, printer status information is displayed.
Media Types: Other
Selecting Other enables additional menus for manual media setup. When changing values,
holding the +/- buttons continuously increments or decrements the value repeatedly.
Follow the steps below for this media type option:
1. You then see:
MEDIA MENU
Other
2. Press the ACCEPT button. You then see:
MEDIA MENU
thickness: (2.00 - 30.00) mil
The range for thickness values is 2.00-30.00 mils. The media thickness is typically
on the media container label, if any. The media thickness changes by .05 mils.
Use the +/- buttons to increment or decrement the thickness setting.
3. Press ACCEPT. You then see:
MEDIA MENU
takeup core OD: (3.10" - 4.00")