Océ CS9360, Operation Instructions Manual

Page: 49 / 134

CS9350 OPERATION MANUAL
3-49
Step 4:
Check the both ends and the centre of the print result that printed with Adjust pattern, and
select the number from 1 to 7 that is not out of alignment.

“6” is selected in the next printing sample.
NOTE

“4” is the current setting value.
Step 5: “Pattern *: 4" (* indicates a pattern name as shown below) is displayed.

The pattern name (*) differs depending on the set print mode.
The print modes and their pattern names are as follows.
Step 6: Press [+] or [–] to enter the number that you selected in Step 4.
NOTE

When you press [Cancel], the input operation is not executed and “Adj.3: Fine Pattern” is
displayed.
PrintMode PatternName
Quality 1, 2 C
Quality 3, 4 B
Graphics 1, 2 E
Graphics 3, 4 D
Banner 1, 2 A
Banner 3, 4 A