Océ CS9360, Operation Instructions Manual

Page: 81 / 134

CS9350 OPERATION MANUAL
4-81
4.3.4 Cutting media manually
CAUTION

Right after printing, the media guide becomes very hot.
Allow the media guide to cool down before the next operation.
Step 1:
Verify the following regarding the operational condition of the product.

Printing or other operations are not in progress.

The operation panel display is Normal.
Step 2: To change the position to cut the roll media, refer to “4.4.1 Feeding media” and advance the
roll media to the desired cut position.
Step 3:
Place a razor blade on the media cut groove on the media guide, and cut the roll media.
CAUTION

Pay attention to the following points when cutting roll media.
Mishandling the razor blade may cause a cut on your finger or hand.

When you hold media, do not place your finger on the media cut groove.

Move the razor blade along the media cut groove.

The procedure for cutting the roll media is complete.
NOTE

When loading the new roll media, cut the front edge of the media if it is not straight.
N° Name
1 Media guide
2 Media cut groove
3 Razor blade
2
1
3