Océ CS9360, Operation Instructions Manual

Page: 80 / 134

CS9350 OPERATION MANUAL
4-80
NOTE

If a large amount of data is saved on the printer, the operation panel may not return to
Normal by a single [Cancel] operation.
In such cases, wait for a few seconds and press [Cancel] again.
4.3.3 Cutting media
If Media ejection mode is set to “Cut”, the printer cuts the media automatically after printing.
5.1.6 Output Mode menu
If you press [Cutting] more than two seconds while the operation panel is Normal, you can cut the media
at the desired position.
Step 1:
Confirm that the operation panel is Normal.
Step 2: Press [Cutting] for more than two seconds.

The printer feeds the roll media to the length of the margin and cuts the media.
NOTE

When loading the new roll media, cut the front edge of the media if it is not straight.

The cutter is a consumable component. Replace it periodically.
6.1.3 Replacing Cutter

When the media detection is set to “Off”, the media cannot be cut automatically.
Printer status Operation with [Cancel] pressed for two seconds
During printing Terminates the printing, and deletes one data remaining in the printer.
Receiving data/analyzing data Deletes the data already received and converted.