10
OEM6 Family Installation and Operation User Manual Rev 7
Notices
The following notices apply, as appropriate, to the OEM6 family products including the OEM615, OEM617D,
OEM628 and OEM638 as well as the FlexPak6.
FCC Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The FlexPak6 has been tested and found to comply with the radiated and conducted emission limits for a
Class B digital device. The Class B limits are designed to provide reasonable protection against harmful
interference in a residential installation.
The equipment listed generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and the receiver
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
Industry Canada
FlexPak6 Class B digital apparatus comply with Canadian ICES-003.
FlexPak6 appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
CE Marking
The FlexPak6 carries the CE mark.
Emissions
OEM6 family products have been designed and tested to meet regulatory emission limits. Emission levels may
be higher for OEM6 family card level operation than for integrated enclosure level products, like the FlexPak6,
using an OEM6 family card.
The OEM615, 628 and 638 cards emission status is Class B. The OEM617D is Class A.
Changes or modifications to this equipment, not expressly approved by NovAtel Inc., could
result in violation of FCC, Industry Canada and CE Marking rules and void the user’s
authority to operate this equipment.
To maintain compliance with the limits of a Class B digital device, you must use properly
shielded interface cables (such as Belden #9539 or equivalent) when using the serial data
ports, and double-shielded cables (such as Belden #9945 or equivalent) when using the I/O
strobe port.
