24
Manual No. NT-0-350 - Rev. May 2021
NOVA Truck Lock
™
Standard Profile Manual
HOUSING COVER
ACTIVATION WAND
SET SCREW
SWITCH ASSEMBLY
UPPER TAPPED HOLE
LOWER TAPPED HOLE
SWITCH WIRES
BUTTON HEAD
CAP SCREW
FIGURE AK
—
RIG SENSOR ASSEMBLY
Step 6:
Install ½” thin wall conduit to shield sensor
switch wire running to control box as shown. See
Figure AL.
3/4" CONDUIT RUN
MAKE SURE ELBOW CLEARS ADJUSTMENT
NUT ON LOWER PULLEY ASSEMBLY
(1/2" CONDUIT ELBOW SUPPLIED BY INSTALLER)
FIGURE AL
—
SHIELD SENSOR WIRE FROM SWITCH TO
CONTROL BOX
INSTALLATION INSTRUCTIONS
Step 7:
Route wires from RIG sensor to inside of
control box through the grommeted hole in the bottom
of the box. See Figure AE on Page 18. Cut to length
and connect to terminal strip. See Figure AF on Page
18.
REAR IMPACT GUARD (RIG) SENSOR
(OPTIONAL FEATURE)
Step 1:
Locate switch housing tube on restraint
housing tube. The top of the switch housing tube
should be flush with the top of the restraint housing
tube and pushed towards the Ram tube. Mark and drill
1/8” pilot holes.
Step 2:
Attach switch housing tube using 1/4-14x1”
self drilling screws.
SWITCH HOUSING TUBE
RESTRAINT
HOUSING TUBE
MARK AND DRILL
PILOT HOLES
RAM TUBE
FIGURE AJ
—
ATTACH SWITCH HOUSING
Step 3:
Insert activation wand in the wand holder
on the switch assembly, tighten set screw to secure
activation wand in place. See Figure AK.
Step 4:
Let switch wires hang through the bottom of
switch housing, fasten button head cap screw to lower
tapped hole on switch assembly. See Figure AK.
Step 5:
Place activation wand in slot on housing
cover and slide cover down to switch housing. Place
button head cap screw through hole in housing cover
and switch housing, then fasten to upper tapped hole
on switch assembly. See Figure AK.
DANGER
DANGER
Post safety warnings and barricade work area,
at dock level and at ground level, to prevent
unauthorized use of the dock position.
Summary of Contents for Standard Profile Truck Lock Series
Page 2: ......