13
Manual No. NT-0-350 - Rev. May 2021
NOVA Truck Lock
™
Standard Profile Manual
INSTALLATION INSTRUCTIONS
NOTICE
Make sure cable is tracking in pulleys, cable
should run over pulley on housing.
Step 7:
Mount lower pulley assembly to foundation
directly beneath upper pulley assembly. In northern
climates, where driveway heaving (freezing) is
possible, the lower pulley swivel bracket may be
installed 2-3” above the drive. See Figure N.
UPPER PULLEY SWIVEL
BRACKET ASSEMBLY
LEVEL
CONDUIT LENGTH (DISTANCE BETWEEN
UPPER AND LOWER PULLEY SWIVEL
ASSEMBLY PLUS 2 3/4")
LOWER PULLEY SWIVEL
BRACKET ASSEMBLY
CONDUIT LENGTH (A SLIGHT PITCH
MAY BE DESIRED TO ALLOW WATER
TO DRAIN) (DISTANCE BETWEEN UPPER
AND LOWER PULLEY SWIVEL ASSEMBLY
PLUS 2 3/4")
LEVEL
FIGURE N
—
LOWER PULLEY LOCATION
NOTICE
Leave adjustment nut on lower pulley swivel
assembly in the middle during restraint
assembly. See Figure O.
LEAVE ADJUSTMENT NUT IN
THE MIDDLE FOR NOW
LOWER PULLEY SWIVEL
BRACKET ASSEMBLY
FIGURE O
—
ADJUSTMENT ON LOWER PULLEY
Step 8:
Remove ram from housing and carefully
pour in 2 quarts (8 cups) of NOVA Juice-E. See Figure
P.
POUR NOVA JUICE
INTO RAM BAR
OPENING IN HOUSING
FIGURE P
—
LOCATION WHERE TO POUR NOVA JUICE
Step 9:
Measure distance between conduit collar on
upper pulley bracket and conduit collar on lower pulley
swivel bracket and add 2-3/4”. Cut a piece of ¾” thin
wall conduit to these lengths. See Figure Q.
THIS DISTANCE PLUS
2-3/4" WHEN LOWER
PULLEY SWIVEL BRACKET
IS RETRACTED
THIS
DISTANCE
SET SCREW
FIGURE Q
—
DISTANCE BETWEEN PULLEYS
Summary of Contents for Standard Profile Truck Lock Series
Page 2: ......