14
Manual No. NT-0-350 - Rev. May 2021
NOVA Truck Lock
™
Standard Profile Manual
INSTALLATION INSTRUCTIONS
Step 10:
Measure distance from conduit collar on
lower pulley to conduit collar on extension bracket and
add 2-3/4”. Cut ¾” thin wall conduit to length as above.
Slide end into tube on lower pulley. Thread cable
through lower and upper pulley assemblies. Allow
free cable end to stick out of conduit at top pulley. Do
not attempt to feed through building wall at this time.
Slide end of conduit into conduit collar on ram housing
and secure with set screw. See Figure Q.
Step 11:
Route ram cable around top of upper
outside pulley, into building through hole in wall, and
over the pulley. See Figure R.
CABLE
THROUGH WALL
TO CONSOLE
PULLEY
CONDUIT
UPPER PULLEY
SWIVEL BRACKET
ASSEMBLY
FIGURE R
—
CABLE ROUTED THROUGH PULLEY
Proceed to one of the following Console
installation instructions:
Manual Console Installation: Page 14
Pneumatic Console Installation: Page 18
NOTICE
A step using the manual Truck Lock™ is noted
with the letter “M” behind the step number.
Example: 5M.
A step using the pneumatic Truck Lock™ is
noted with the letter “P” behind the step number.
Example: 4P.
Summary of Contents for Standard Profile Truck Lock Series
Page 2: ......