![background image](http://html1.mh-extra.com/html/nova-technology-international-llc/standard-profile-truck-lock-series/standard-profile-truck-lock-series_owner-and-user-manual_1710473014.webp)
12
Manual No. NT-0-350 - Rev. May 2021
NOVA Truck Lock
™
Standard Profile Manual
INSTALLATION INSTRUCTIONS
Step 3:
First, drill the 1” diameter cable exit hole
through the wall from the inside at the location marked
in Figure I. Replace bracket and check alignment of
the 1” hole per Figure K, then drill mounting holes.
NOTICE
To prevent outside concrete wall from chipping,
drill a 1/2” pilot hole first. If drilling into a block
wall, loose insulation, etc., sleeve the hole with a
section of 3/4” conduit.
1
4 "
4"
1
2 "
2"
1" CABLE EXIT HOLE
FIGURE K
—
CABLE EXIT HOLE LOCATION
NOTICE
Use truss head expansion bolts, toggle bolts
or through bolts as appropriate. Bolts and
fasteners supplied by installer.
Step 5:
Align the top of the pulley with the center
of the 1” hole in the wall and mount the upper swivel
bracket assembly to the exterior wall. See Figure J &
L.
UPPER PULLEY SWIVEL
BRACKET ASSEMBLY
4 FASTENERS SUPPLIED BY OTHERS
FIGURE L
—
FASTEN UPPER PULLEY SWIVEL BRACKET
FLANGE MOUNT ONLY Step 6:
Insert 1/2-
13x4-1/2” bolt through hole furthest from dock side and
the tail section. Place tail section in place up to dock
wall. Mark location and pivot up around the 1/2” bolt.
Insert 3/8-16x1” flange head bolts and flange nuts
in slot to stop travel of the tail section away from the
dock. Pivot down and insert other 1/2-13x4-1/2” bolt
through hole closer to the dock. Tighten both nylock
nuts. See Figure M.
NOTICE
Recessed building wall or dock foundation wall
may require a special bracket as per your survey
sheet.
FIGURE M
—
SECURING TAIL SECTION TO HOUSING
A
A
CABLE MUST RUN ON PULLEYS
OUTSIDE WALL
CONTROL CONSOLE
UPPER PULLEY SWIVEL ASSEMBLY
CABLE
CABLE MUST NOT RUB ON
WALL MAERIAL
FIGURE J
—
INSIDE & OUTSIDE PULLEY TRACKING
NOTICE
Proper alignment of the Inside and Outside
pulleys is required to prevent damage to the
cable from abrasion with the outside wall. See
Figure J.
Step 4:
Replace console pole and confirm alignment.
Then drill mounting holes and mount control console
on inside of building wall.
CAST-IN ONLY Step 6:
Bolt E.O.D. extension
bracket to dock side of ram housing with supplied
bolts. E.O.D. extension bracket should touch dock face
when positioned properly.
Summary of Contents for Standard Profile Truck Lock Series
Page 2: ......