![background image](http://html1.mh-extra.com/html/nova-technology-international-llc/standard-profile-truck-lock-series/standard-profile-truck-lock-series_owner-and-user-manual_1710473018.webp)
16
Manual No. NT-0-350 - Rev. May 2021
NOVA Truck Lock
™
Standard Profile Manual
INSTALLATION INSTRUCTIONS
Step 12M:
Raise handle to full up position. Make
sure upper limit switch lever is contacting Activation
Handle Tube. Pull cable tight and attach to spring
using cable clamp. Run excess cable down center of
spring, exiting on right side of handle. Cut off cable
flush with bottom of spring. See Figure S.
CUT OFF EXCESS CABLE
ACTIVATED LIMIT SWITCH
HANDLE IN FULL
UP POSITION
FIGURE S
—
SETTING UP MANUAL CONSOLE
Step 13M:
Determine location of outside light on
exterior of building. Light must be on truck driver
side of dock door (Right side when facing dock from
outside). Verify location of light will not interfere with
the future installation of dock shelters or seals. Drill
hole through wall at approximate center of light. Feed
wire from light through hole in wall and affix light to
wall.
2-3"
FIGURE T
—
MOUNTING CONTROL BOX
Step 15M:
Route wires from outside light to inside
control box through the grommeted hole in the bottom
of the box. See Figure U. Cut to length and connect to
terminal strip. See Figure V & W.
GREEN
LIGHT
RED WIRE
FROM LIGHT BOX
BLACK WIRE
FROM LIGHT BOX
RED WIRE FROM LIGHT BOX
(MARKED WITH "GREEN LIGHT" TAG)
RL
-V
GL
RED LIGHT
GREEN LIGHT
OUTSIDE LIGHT COVER
TO
CONTROL
BOX
OUTSIDE LIGHT WIRING
FIGURE V
—
OUTSIDE LIGHT WIRING
MANUAL CONSOLE INSTALLATION
(See Page 18 for pneumatic console
installation)
FIGURE U
—
ROUTE WIRES THROUGH GROMMETS
HORN
OPTIONAL
RIG SENSOR
WIRES
POWER CORD
OUTSIDE LIGHT
WIRES
CONTROL BOX
Step 14M:
Mount control box to wall 2” to 3” above
console using fasteners supplied by installers. See
Figure T.
OUTSIDE LIGHT
Summary of Contents for Standard Profile Truck Lock Series
Page 2: ......