11
Manual No. NT-0-350 - Rev. May 2021
NOVA Truck Lock
™
Standard Profile Manual
INSTALLATION INSTRUCTIONS
NOTICE
Use (7) 5/8 x 5 inch orange tip wedge bolt
(Supplied by NOVA). Wedge bolt is a heavy duty
self-tapping anchor. Meets AISI 1020/1040 carbon
steel. Blue tip wedge bolts are not allowed.
Refer to Power Fasteners, Inc. Wedge Bolt
#7221. Nova P/N 40-0-112.
Step 4:
Place housing in sheath and insert orange
tip wedge bolts. To insert wedge bolt, drill a 5/8 inch
hole through concrete in first location. Clean out hole
with compressed air. Drive wedge bolt into prepared
holes until clamping the mounting plate to concrete.
Do not exceed 75 ft-lbs of torque. DO NOT insert a
wedge bolt in any holes in which reinforcing rod is
encountered. If rebar is encountered, use a 5/8 inch
diameter x 5 inch long Powerbolt. One Powerbolt is
included with each restraint. If more than 1 bolt hits
rebar consult factory at 800-236-7325.
CONSOLE INSTALLATION
NOTICE
Verify there are no obstructions on outside of
building which would interfere with cable run
between control console and ram housing.
Position control console so that activation
cable clears dock bumpers. Also, verify there is
adequate clearance for future installation of dock
seals or shelters. See Figure H.
DOCK SEAL
TRUCK LOCK
DOCK LEVELER
UNOBSTRUCTED ZONE
FIGURE H
—
CLEARANCE FOR SEALS AND SHELTERS
Step 1:
Remove cover from control console by
removing four 3/8” x 1/2” bolts. If metal building
support is required as per survey sheet, follow those
instructions for correct installation.
Step 2:
Temporarily place control console (with
cover removed) against inside wall in desired location.
Verify the console is parallel with the wall. Mark the
four mounting holes for the console (two on wall and
two on floor) as well as the 1” diameter cable exit hole.
See Figure I.
1
4 "
1"
MARK HOLE
LOCATIONS
ON WALL
FIGURE I
—
PULLEY BRACKET HOLE LOCATIONS
Summary of Contents for Standard Profile Truck Lock Series
Page 2: ......