Nortel Meridian Meridian 1, Planning, Installation And Operating Instructions

Page: 95 / 556

Page 76 of 536 Chapter 8 – Installing a new system
553-3121-210 Standard 3.0 January 1999
10 Connect the SDI interfaces on the SSC card to the appropriate SDI
port cables. If required, connect the ethernet cable to the ethernet
interface connector in the main cabinet. Refer to
“Chapter 15 –
Installing and connecting SDI and Ethernet ports” on page 125 .
Make sure the baud rate and device option settings are properly set.
If the equipment operates in DTE mode, make sure that the A0601396
or A0601397 Modem eliminator is installed.
Connect communication equipment such as TTY terminals and
modems to the SDI cables.
11 Start up and test the system as described in
“Chapter 16 – Starting up and testing the system” on page 139 .
Check all connections and make sure that the circuit cards are properly
installed.
Make sure that the circuit breaker in each cabinet is set to ON.
If the system is equipped with one or more expansion cabinets, check
the fiber related LEDs on the SSC card.
• The LED for the Expansion Daughterboard should be green.
• If it is red (disabled indication);
Load overlay program 135 and enter ENL FL1 for first
expansion cabinet, or ENL FL2 for the second expansion
cabinet.
• If the LED is yellow (fault indication):
Check the fiber optic cable to make sure that it is properly
connected and not damaged.
12 Connect the M2616 or M2008 administration and maintenance
telephone equipped with a display. Configure it as Model 99.
Refer to
“Chapter 17 – Connecting the telephones and attendant
console” on page 157 .
Make sure that it is activated as a model 99.