Nortel Meridian Meridian 1, Planning, Installation And Operating Instructions

Page: 450 / 556

Chapter 24 – Changing pre-programmed data Page 431 of 536
Option 11C Compact Planning, Installation, Fault Clearing and CCBR Guide
Removing telephone models
Use LD 10 to remove analog telephone models and LD 11 to remove digital
telephone models. Respond as follows to the prompts in either overlay:
LD 10 or LD 11
REQ OUT
TYPE XXXX M “XXXX” = telephone type for the model
you are removing (Example: 500, 2006,
2317, 2216, 3000, etc.)
CUST 0
MODL YYY “YYY” = the model number associated
with the telephone type you are removing
(Valid range is 1-127).
Creating trunk models and changing route access codes
Use overlay program 14 to create trunk models different from the default
models provided in the system software. Route access codes are changed
using the administration telephone.
For additional assistance when creating trunk models, refer to the Option 11c
Compact Software Guides that are shipped with every system.
Creating trunk models
To create a new trunk model, load LD 14 and type in the following commands
on the TTY:
LD 14
REQ NEW
TYPE aaa M “aaa” = the type of trunk that you are
creating (TIE, COT, WATS, and so on).
MODL YYY “YYY” = the model number of the trunk being
created (between 1 - 127)