Nortel DualMode 800, Maintenance Manual

Page: 54 / 216

1-40 Equipment operation Nortel Networks Confidential
411-2051-500 Draft 00.01 November 1999
Command line mode measurement commands
Measurements of operational parameters are taken periodically and on
demand from the ICP or the terminal interface. If a measurement exceeds a
threshold value, the ICP receives an alarm message. Table 1-5 gives the name,
command, state, and action for the Command line mode measurement
commands.
Table 1-5
Command line mode measurement commands
Name Terminal
Command
Personality
Allowed
Description
Audio Sensitivity
Settings Query AUDSENS VCH The audio sensitivity settings in dBm for the
transmit and receive paths.
Continuous
Status Display Query STATUS
on|off DIV|ALL|CUR
R|ST|SAT|A VCH Enables/disables a continuous display of
channel number, RSSI, SAT, and ST of the
diversity port or the channel number and RSSI
readings from each port.
Digital
Verification Color
Code Query DVCC TTC The DVCC status for each slot.
In TRU3, the status indicates the actual SAT
value.
Display SWERR
Table Query SWERR Any The SWERR Class, SWERR Code, and
associated information words.
Hardware
Version Number Query HWVERS Any The hardware release number of the TRU
being queried.
MPA or PA
Firmware Version
Number Query MPAFW or
PAFW Any The MPA/SCLPA firmware version number of
the DRU being queried.
Note:
DualMode 800 Enclosure does not
support MPA or SCLPA.
Multicoupler Gain
Settings Query MCGAIN Any The multicoupler gain compensation in dBm for
each antenna on both receive paths.
PA Maximum
Power Setting Query MAXTXPOW VCH, CCH,
or TTC
The adjusted maximum TX power setting in
dBm, stored in the TRU and the delta adjust
from the MCPA.
PA Power Step
Size Query
TXPOWSTEP VCH, CCH,
or TTC The adjusted TX power step size setting in dB,
stored in the TRU and the delta adjust from the
MCPA.
- continued -