Nortel DualMode 800, Maintenance Manual

Page: 159 / 216

DRU transmit tests 11-21
Wireless Solutions DualMode 800 Enclosure Maintenance Manual MTX08
Setting TX audio deviation to site operational level
After the transmit tests, ensure that the deviation level recorded in the
Transmit Audio Level test is the same as the site specific operational level. If
the levels are different, perform the Transmit Audio Level test and change the
level to the site specific operational level by using the T command.
Set the TX audio sensitivity with the T command.
>T
The TRU will prompt as follows:
Enter TX or RX and a decimal dBm value (TX:-28...
-10);(RX:-28...-16)
Enter:
>TX -xx.x
(change this value as required to obtain the operational
transmit audio level)
Note: A change of 1 dBm is approximately a change of 0.27 kHz
deviation.
The Audio Sens TX status on the screen will show:
Audio Sens Tx: -xx.x
(site specific operational level)
Use the C command to turn off the carrier of the TRU.
>C
The PA (TRU transmitter) status on the screen will show:
PA: off
Use the Y command to perform a reset on the TRU after the tests.
>Y
At the command prompt, perform a warm reset on the TRU by entering:
>W
The TRU will return to its normal working condition after the reset.
Disconnect the interface terminal from the TRU.
At the MTX, put the TRU back to service.